Mitsubishi — 14.6 DMCNET Motion Control

AH500 Motion Control Module Manual signal from low to high occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs. Mode 10: The motor used rotates counterclockwise. After the motor comes into contact with the positive limit switch specified, it will rotate clockwise. After a transition in DOG’s signal from low to high occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is 11, 12, 13, or 14. If the value in SR1078 (SR1178, SR1278…) is 11, 12, 13, or 14, the motor used will rotate clockwise, and search for a transition in DOG’s signal.

There are three situations. a. The motor used does not find a transition in DOG’s signal or does not come into contact with the negative limit switch specified. Mode 11: The motor used rotates clockwise. After a transition in DOG’s signal from low to high occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs. Mode 12: The motor used rotates clockwise. After a transition in DOG’s signal from low to high occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs. Mode 13: The motor used rotates clockwise.

After a transition in DOG’s signal from high to low occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs. Mode 14: The motor used rotates clockwise. After a transition in DOG’s signal from high to low occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs. b. The motor used rotates when DOG’s signal is ON. Mode 11: The motor used rotates counterclockwise. After a transition in DOG’s signal from high to low occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs. Mode 12: The motor used rotates counterclockwise.

After a transition in DOG’s signal from high to low occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs. Mode 13: The motor used rotates clockwise. After a transition in DOG’s signal from high to low occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high. Mode 14: The motor used rotates clockwise. After a transition in DOG’s signal from high to low occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs. 14-14