AH500 Motion Control Module Manual Setting the parameters of an RS-232 driver Users can type a driver name in the Driver Name box. Select RS232 in the Type drop-down list box in the Connection Setup section. Select an RS-232 communication port in the COM Port drop-down list box. Each item in the COM Port drop-down list box is composed of a device name and a communication port number. The communication ports in the COM Port drop-down list box are the same as the communication ports in the Device Manager window. The communication format used can be ASCII or RTU .
The communication protocol for exchanging data through a communication port selected must be the same as the communication protocol for exchanging data through a communication port on a device connected. If users click Default , the values of all communication parameters will return to their default values. If users do not know the communication protocol for exchanging data through a communication port on a device connected, the users can connect the device to an RS-232 communication port selected with an RS-232 cable, and click Auto-detect to automatically detect the communication protocol.
If the communication protocol is detected successfully, the related communication parameters in the Driver Properties window are set. However, when the communication protocol is detected automatically, the COM Port parameter and the ASCII/RTU parameter are not detected. As a result, the users have to set the COM Port parameter and the ASCII/RTU parameter before clicking Auto-detect . Users can select the number of times the sending of a command is retried if a connection error occurs in the Time of Auto-retry box, and select an interval of retrying the sending of a command in the Time Interval of Auto-retry box. 15-6