Chapter 15 Setting USB Communication in PMSoft Setting the parameters of an Ethernet driver Users can type a driver name in the Driver Name box. Select Ethernet in the Type drop-down list box in the Connection Setup section. Select a network interface card in the Description drop-down list box. An IP address assigned to a network interface card selected is displayed in the lower left corner of the Ethernet Card section. Owing to the characteristics of Ethernet, a computer can communicate with all devices on a network. Users can create the IP addresses of devices connected to this driver in the IP Address Setting section.
After users click Add to add a new IP address to the list of IP addresses in the IP Address Setting section, they can type related information in the IP Address section, the Port Number column, and the Comment column. Users can type the IP address of a device connected in this cell. Users can type the communication port number specified. Users can type a comment in this cell. After users select an IP address, they can click Del or press DEL on the keyboard to delete the IP address from the list.
Users can select the number of times the sending of a command is retried if a connection error occurs in the Time of Auto-retry box, and select an interval of retrying the sending of a command in the Time Interval of Auto-retry box. After the users set the parameters of a driver, and click OK in the Driver Properties window, the parameters related to the driver will be displayed in the COMMGR window. The creation of a driver is equivalent to the creation of a connection. The users can start or stop the 15-7