Delta Electronics AH500 — 6.6.3 Connection Test

Chapter 6 Writing a Program (3) After the users click Download on the Option menu, or on the toolbar, the Transfer Items window will appear. The hardware configuration will be downloaded to the CPU module after OK is clicked. (4) After the hardware configuration is downloaded to the CPU module successfully, the BUS FAULT LED indicator on the CPU module will be OFF. The users can close the HWCONFIG window. If the BUS FAULT LED indicator on the CPU module is still ON or blinking, the CPU module is in an abnormal state.

Please make sure that the actual hardware configuration is the same as the hardware configuration in the HWCONFIG window again, or refer to the operation manual for more information about eliminating the error. Please refer to chapter 8 for more information about HWCONFIG.  Downloading the program After the program is compiled successfully, the users can click the PLC menu, point to Transfer , and click Download . The users can also click on the toolbar after the program is compiled successfully. Select the Program checkbox and the Comments checkbox in the Transfer Setup window so that the program in the CPU module can be uploaded later, and then click OK .

6.6.3 Connection Test After a program is downloaded to a PLC, users can monitor the execution status of the PLC through ISPSoft. There are two monitoring modes that ISPSoft provide. One is the device monitoring mode, and the other is the program monitoring mode. 6-27 Monitoring mode Description Device monitoring mode Users can monitor the statuses of the devices in the PLC through the monitoring table. In this mode, ISPSoft only needs to update the statuses of the devices. The present program in ISPSoft does not need to be the same as the program in the PLC.