AH500 Operation Manual If the sending of a command fails, the CPU module will retry the sending of the command. Users can set the number of times the sending of a command is retired in this box. The number of times the sending of a command is retired must be in the range of 0 to 20. Users can set an interval of retrying the sending of a command. If the sending of a command fails, the CPU module will retry the sending of the command every specific period of time. The interval of retrying the sending of a command must be in the range of 100 milliseconds to 65535 milliseconds. *. The parameters set in HWCONFIG must be downloaded to the CPU module so that they can take effect.
(Please refer to section 8.2.6 or section 8.4.4 for more information.) 8.2.4 Ethernet ─ Basic If a CPU module is equipped with an Ethernet port, users can enter this page. For example, AHCPU5xx-EN is equipped with an Ethernet port. After users click the Ethernet─Basic tab at the top of the window, they can set the Ethernet port in the CPU module. The users can set the communication parameters for the Ethernet port in the CPU module in this page. They can refer to section 2.4.7 in ISPSoft User Manual for more information about connecting to a CPU module through the Ethernet port on the CPU module, and refer to other related documents or manuals for more information about Ethernet.
If users select Static in the IP Addressing Mode drop-down list box, they can specify an IP address. If Dynamic is selected in the IP Addressing Mode drop-down list box, an IP address is assigned by a DHCP server. If Static is selected in the IP Addressing Mode drop-down list box, users can assign an IP address, a subnet mask, and a gateway address. If no data is transmitted from the CPU module on a network, and the keepalive period has elapsed, the CPU module will be disconnected from the network automatically.
If Dynamic is selected in the IP Addressing Mode drop-down list box, the IP address, the subnet mask, and the gateway can be read from the CPU module by means of the following steps. (1) Connect the CPU module to Ethernet, and make sure that the network and the CPU module operate normally. (2) Select Dynamic in the IP Addressing Mode drop-down list box, and download the parameter to the CPU module. (3) After Refresh is clicked, the system will read the IP address, the subnet mask, and the gateway from the CPU module. The IP address, the subnet mask, and the gateway will be displayed in the boxes. 8-37