Delta Electronics AH500 — 8.3.2 Setting the Parameters in a Module

Chapter 8 Hardware Configuration Select a version number in the Firmware Version drop-down list cell. After the setting is complete, users can click OK to change the firmware versions of the modules specified. Additional remark Users can know the firmware version of an actual module by clicking I/O Scan on the Option menu. If ISPSfot is connected to the CPU module, users can get the information about the firmware version of an actual module in the Module Information window.

If users want to know the firmware version of an actual module by click I/O Scan on the Option menu, or view the information about the firmware version of an actual module in the Module Information window, ISPSoft must be connected to the CPU module normally, and the installation of modules must be completed. Please refer to section 8.4.5 and section 8.4.6 for more information. 8.3.2 Setting the Parameters in a Module Users can set the parameters in every module configured in HWCONFIG. The functions and characters of every module depend on the setting of the parameters. If users want to set the parameters in a module, they can double-click the module in the system configuration area.

The system will automatically open the Parameter Setting window. The parameters are set according to the functions supported by the module. Before users set the parameters, they have to refer to AH500 Module Manual for more information. To prevent damage to the system or staff, the users have to make sure of the effect that the parameters which are set have on the module and the whole system. 8-52