Chapter 8 Hardware Configuration 8.4 Management of the Parameters in AH500 Series Hardware and Online Diagnosis 8.4.1 Saving and Printing a Hardware Configuration After a hardware configuration is complete, the setting in HWCONFIG can be saved with the whole project. The contents which are saved include the hardware configuration, the parameters in the modules, and the parameters in the CPU module, but do not include the parameters in the intelligent modules. The parameters in the CPU module are saved as a para file whose primary filename is the project name. The hardware configuration and the parameters in the modules are saved as an hw file whose primary filename is the project name.
The files are saved in a folder in which the project (*.isp) is saved. If users want to save the setting in HWCONFIG, they can click Save on the File menu, or on the toolbar. If users want to perform a printing task, they click Print on the File menu to open the Print Preview window. The contents which are printed only include the configuration in the configuration area. Please refer to appendix C for more information about the Print Preview window.
Additional remark If the CPU module is changed in ISPSoft after the setting of the parameters in the hardware is complete, and the new CPU module can not completely support the range of devices set for the original hardware, a warning message appears when the HWCONFIG window is opened again. The problematic modules are marked with triangular error signs in HWCONFIG. These modules are in an abnormal condition. The Download function and the Online Mode function can not be enabled. After the incorrect device addresses are modified, users can proceed with the operation. Besides, the triangular error signs will disappear after the incorrect devices addresses are modified. 8-58