Delta Electronics AH500 — 8.3.4 Setting the Parameters in an Intelligent Module

AH500 Operation Manual 8.3.4 Setting the Parameters in an Intelligent Module Delta Electronics, Inc. provides the exclusive configuration tools for some modules. Through the software, the modules can be configured further, and the parameters in the modules can be set further. Some of the configuration tools can be opened through HWCONFIG. The configuration tools supported by HWCONFIG are listed in the table below. The table suggests that the configuration tools for modules which are not listed in the table can not be opened through HWCONFIG. It does not suggest that there are no configuration tools for modules which are not listed in the table. *1.

DCISoft version 1.08 or above can be opened through HWCONFIG. Users can select a version of DCISoft according to the specifications for AH10SCM-5A and their requirements. *2. The configuration tool for AH10SCM-5A is SCMSoft. After DCISoft version 1.08 or above is installed, SCMSoft can be used. If users want to set the parameters in an intelligent module, they can right-click the module in the system configuration area, and click Intelligent Module Configuration on the context menu. If the configuration and the setting of the parameters in HWCONFIG have not been saved, the system will ask the users to save the configuration and the setting before the corresponding software is started.

If the corresponding software is started, the users can not perform any editing tasks in HWCONFIG before the software is closed. Please refer to instructions for software and modules for more information about the usage of the software. 8-57 Module type Module model Software supported and its version Network module AH10EN-5A The configuration tool is in HWCONFIG, and does not need to be installed. AH10SCM-5A DCISoft version 1.08 or above needs to be installed.