Chapter 8 Hardware Configuration 8.4.5 I/O Scan Users can configure modules in the way mentioned above. If users have gotten related hardware, they can install the hardware, click I/O Scan in HWCONFIG, and scan the actual hardware configuration through communication. The time of configuring the modules will be saved. Users have to make sure that ISPSoft has connected to the CPU module normally before they carry out the operation. Please refer to section 2.4 in ISPSoft User Manual for more information about communication setting. Users can click I/O Scan on the Option menu, or on the toolbar to carry out the operation.
The contents which will be scanned include the module models, the hardware configuration, and the firmware versions of the modules, but do not include the parameters in the modules and the parameters in the CPU module. After I/O Scan is clicked, the original hardware configuration and the parameter setting will be cleared. However, the parameters in the CPU module will not be affected.
After the scan is complete, the actual hardware configuration will be displayed in the system configuration area, the system will assign input/output devices to the modules, the parameters in the modules are assigned the default values, and the firmware versions set in HWCONFIG will be the actual firmware versions of the modules. If the firmware version of a module which is scanned is higher than the firmware version of the module in the MDS document, the highest version which can be selected will be displayed in the Firmware Version drop-down list cell for the module, and the actual firmware version of the module will be displayed in the Comment cell for the module. *.
Please refer to section 8.3.1 for more information about MDS documents and firmware versions of modules. The difference between I/O Scan and Upload can be illustrated with the following example. If I/O Scan is clicked, the hardware configuration will be scanned, and the parameters in the modules will not be scanned. If Upload is clicked, the hardware configuration in the CPU module will be read. The hardware configuration uploaded to HWCONFIG may be different from the actual hardware configuration. 8-62