AH500 Operation Manual Changing the values of the parameters in a module If a module is assigned data registers, users can change the values in the data registers after the hardware configuration enters the online mode. However, on account of the design of the module, the CPU module and the module may need to run to produce the values of the parameters before the values in the data registers are changed. (1) If the hardware configuration is in the online mode, users can double-click a module to open the Parameter Setting window, and click a parameter type which will be set at the left side of the window.
The users will find that the appearance of the table in the window is quite different from the appearance of the table in the offline mode. (2) The present values of the parameters are displayed in the PV column, but they are not updated timely. After users click in the window, the system will retrieve the present values again, and the values retrieved will be displayed in the PV column. (3) If users want to change the values in the data registers assigned to the parameters, they can type the setting values in the SV column. Users can only type the setting values in the SV cells for the parameters to which the data registers are assigned.
If users want to change the values of parameters, they can type the setting values in the SV cells for the parameters, and click after the typing of the setting values is complete. The values of the parameters will be written into the data registers assigned to the parameters. *. Before the value of a parameter is changed, users have to refer to the instructions for the module to make sure of the range of values which are allowed. 8-67