Delta Electronics AH500 — 10.2.2 Statuses and Operation under Different Operating Modes

Chapter 10 Operating Principle of the CPU Module 10.1.2 I/O Refreshing and Communication Service  I/O refreshing A CPU module reads external I/O data periodically or output data to external I/O. I/O refreshing includes the following.  Refreshing data in a digital I/O module  Refreshing data in an analog I/O module  Refreshing data in a network module  Refreshing data in a motion control module All I/O refreshing is executed in the same loop. The data in an input device is refreshed before a program is executed, and the data in an output device is refreshed after the program is executed.

 Communication service Communication service is nonscheduled communication service of a network module. It includes the communication request sent from external equipment to a CPU module, and the communication request sent from the CPU module to the external equipment. 10.2 Operating Modes of the CPU Module 10.2.1 Operating Modes There are two operating modes. They can be used to control a user program and all tasks. STOP mode: A program is not executed under this mode. Users can download a module table, initialize CPU configuration and other setting, download a program, check a program, and force a bit ON/OFF. RUN mode: A program is executed under this mode.

Users can not download a module table, and initialize CPU configuration and other setting. 10.2.2 Statuses and Operation under Different Operating Modes The STOP mode and the RUN mode are modes for a CPU module. The statuses and operation under these modes are listed below.  Basic operation 10-3 Unit Maximum data exchange Data exchange area It depends on the number of input/output Digital I/O module Input relay/Output relay channels in the unit. It depends on the number of input/output Analog I/O module Data register channels in the unit. Network module It depends on the unit. Data register Motion control module It depends on the unit.

Data register CPU mode Program I/O refreshing External output Program memory Non-latched Latched area area STOP The execution of the program stops. The I/O refreshing is executed. OFF (If users set the I/O module so that the final state of the external output on the I/O module is retained, the final state of the external output on the I/O module will be retained.) The data in the program memories are retained. RUN The program is executed. The I/O refreshing is executed. The external output is controlled by the program. The program memories are controlled by the program.