AH500 Operation Manual A node shown in the display area in the figure above is described below. The information is composed of a node number, a PLC name, and a model name. The IP address assigned to AH500 series CPU module is 192.168.1.2. The start mode of the Ether Link constructed is Always Run . The IP address assigned to the module installed in slot 0 is 192.168.1.3. The start mode of the Ether Link constructed is Always Stop . >1 block indicate that the data demanded of node 1 will be stored in D110~D119 in node 2. The color assigned to the D block depends on the node number in the D block.
Owing to the fact that there is not any information in the M block and the L block, the M block and the L block does not demand any data of other devices. 11.2.2.3 Creating and Managing a Data Exchange Table If users want to create a data exchange table, they have to click the Table tab in the information area. The node which is selected on the node list is shown in the upper left corner of the information area. The data in the table is related to the node selected. If the users click , a new piece of data will be added to the table. A piece of data is composed of two parts.
The left part of the data in the figure below indicates that the data demanding node AH-01 will store the data demanded in L0 in itself, and the right part of the data in the figure below indicates that the data supply node AH-02 will supply the data in L0 in itself. 11-38