Delta Electronics AH500 — 11.2.2.3 Creating and Managing a Data Exchange Table

Chapter 11 Convenient Functions The steps of setting a data exchange group are as follows. (1) Select a node number in the # cell for the data demanding node. After the users select a node number, the PLC name corresponds to the node number will be appear in the Device Name cell for the node number. If the users select a specific node number rather than All Nodes on the node list, the data in the table will be related to the specific node number selected, and the fixed node number in the # cell for the data demanding node will be the specific node number selected on the node list.

 Users can type a value in (2) Select a device type in the Register cell for the data demanding node, and type an address in the Starting Address cell for the data demanding node. (3) Select a node number in the # cell for the data supply node. The node number in the # cell for the data demanding node can not be the same as the node number in the # cell for the data supply node. After the users select a node number, the PLC name corresponds to the node number will be appear in the Device Name cell for the node number. (4) Select a device type in the Register cell for the data supply node, and type an address in the Starting Address cell for the data supply node.

The device type selected in the Register cell for the data supply node does not have to be the same as the device type selected in the Register cell for the data demanding node. (5) Type a data length in the Size cell. A word is a unit. The maximum data length is 1900 words. After the users type a data length, the device ranges in the Range cells will change according to the data length typed. The users can create data exchange groups by following the steps described above. The device range in the 11-39