Delta Electronics AH500 — 11.2.2.9 Enabling/Disabling the Online Monitoring Function

AH500 Operation Manual Before the users enable the online monitoring function, they have to make sure that all the nodes are connected according to the network framework created in NWCONFIG, and can operate normally. (a) Every node has been connected to a network according to the network framework created in NWCONIFG. (b) The users have set the parameters for Ethernet ports of the nodes by means of HWCOFNIG, and the parameters have been downloaded to the PLCs and the modules. The setting of the parameters must be consistent with the setting in NWCONFIG. (c) The parameters related to an Ether Link have been downloaded to the PLC selected.

(d) Every node is powered up, and can operate normally. A. Enabling a Monitoring Function  Enabling the function of monitoring a single node  Method 1 Select a data demanding node, and then click on the toolbar, or Online (Connect to a Single node) on the PLC menu. When the data demanding node is monitored, on the toolbar is pressed.  Method 2 Select a data demanding node, right-click the data demanding node, and click Online (Connect to a Single Node) on the context menu. When the data demanding node is monitored, on the toolbar is pressed.  Enabling the function of monitoring multiple nodes  Method 1 Click Online (All Nodes) on the PLC menu, or on the toolbar. 11-50