Chapter 11 Convenient Functions After the users set a data exchange block, they have to click OK . The users can use this method to create several data exchange blocks. The users can manage the items in the table by means of the buttons at the right side of the table. The buttons are described below. After the users create a data exchange table, they can select a mode in the Mode drop-down list box. *1. The mode selected will be executed only if the Enable checkbox in the window used to set an item is selected. *2. Please refer to section 11.3.3 for more information about setting flags.
11.3.1.3 MODBUS Data Exchange - Downloading/Uploading Parameters After users set data exchange blocks, they have to download the parameters which are set to the PLC used. This section briefly introduces the downloading/uploading of the parameters set. Please refer to chapter 3 in ISPSoft User Manual for more information. Before the users download the parameters which are set, they have to make sure that ISPSoft connects to the PLC used normally. Please refer to section 2.4 in ISPSoft User Manual for more information.
After the users click in the upper left corner of the PLC Parameter Setting window, parameters set will 11-63 Button Description Move Up Moving the item selected in the table upwards Move Down Moving the item selected in the table downwards Delete Deleting the item selected in the table Copy Copying the item selected in the table, and automatically adding the item which is copied to the bottom of the table Mode Description Program Control The execution of the data exchange is enabled or disabled by means of setting flags*2. If the flags are set to ON, the execution of the data exchange will be enabled. PLC Run When the PLC runs, the data exchange is executed.
Always Enable The data exchange is executed whether the PLC runs or stops.