AH500 Operation Manual 1 x16 0 x16 Example: If users need to set the node address of AH10PFBS-5A to 26 (decimal value), they have to turn the knob corresponding to x16 1 to “1”, and the knob corresponding to x16 0 to “A”. 26 (decimal value)=1A (hexadecimal value)=1x16 1 +Ax16 0 . Points for attention: If users set the node address of AH10PFBS-5A when AH10PFBS-5A is not supplied with power, they have to power AH10PFBS-5A after the node address of AH10PFBS-5A is set.
If users change the node address of AH10PFBS-5A when AH10PFBS-5A is powered, the change will not take effect immediately after the node address of AH10PFBS-5A is changed, and it will take effect after the users cut off the power supplied to AH10PFBS-5A and then power AH10PFBS-5A again. To prevent the address knobs on AH10PFBS-5A from being scratched, please carefully use a slotted screwdriver to rotate the address knobs on AH10PFBS-5A. 2.
Definitions of the pins in the PROFIBUS-DP port AH10COPM-5A 5 9 6 1 7 2-63 Address Definition H’1~H’7D V alid PROFIBUS address H’0 or H’7E~H’FF In valid PROFIBUS address Pin PIN name Description 1 -- N/C 2 -- N/C 3 RxD/TxD-P Sending/receiving data (P (B)) 4 -- N/C 5 DGND Data reference potential (C) 6 VP Supplying positive voltage 7 -- N/C 8 RxD/TxD-N Sending/receiving data (N (A)) 9 -- N/C 1 2 3 4 10COPM RUN ERROR 5 6 x16O Node Address x16N DR 2 DR 1 DR 0 IN 0 CAN+ SHLD CAN- GND 8 9 10 Number Name Description 1 Model name Model name of the module 2 Address knobs For setting an address 3 Function switch For setting a function 4 CANopen connector For a CANopen connection 5 RUN LED indicator Operating status of the module