EPSON — The printer does not print

AL-C300 Series User's Guide Troubleshooting Note: If a configuration status sheet does not print correctly, your printer may be damaged. Contact your dealer or a qualified service representative. The font cannot be printed Printing in the PostScript 3 Mode Problems The problems listed in this section are those that you may encounter when printing with the PostScript driver. All procedural instructions refer to the PostScript printer driver. The printer does not print correctly in the PostScript mode The printer does not print 75 Cause What to do The emulation setting for the port may not be correct. Specify the emulation mode by using the printer’s control panel menus.

See “Emulation Menu” on page 28. Cause What to do For Windows users, you may use the printer fonts substituted for specified TrueType fonts. In the printer driver, choose the Print TrueType fonts as bitmap check box in the Extended Settings dialog box. The selected font is not supported by your printer. Make sure that you have installed the correct font. See the Font Guide for more information. Cause What to do The printer’s emulation mode setting is incorrect. The printer is set to the Auto mode by default, so that it can automatically determine the encoding used in the received print job data and select the appropriate emulation mode.

However, there are situations where the printer cannot select the correct emulation mode. In this case, it must be set manually to PS3. Set the emulation mode through the SelecType Emulation Menu on the printer. See “Emulation Menu” on page 28. The printer’s emulation mode setting for the interface that you are using is incorrect. The emulation mode can be set individually for each interface which receives print job data. Set the emulation mode for the interface you are using to PS3. Set the emulation mode through the SelecType Emulation Menu on the printer. See “Emulation Menu” on page 28. Cause What to do An incorrect printer driver is selected.

Make sure that the PostScript printer driver that you are using to print is selected.