EPSON — Installing a CompactFlash memory

AL-C300 Series User's Guide Troubleshooting ! Caution: B Carefully take the optional paper cassette unit out from its carton and place it where you intend to set up the printer. Be careful when working inside the printer as some components are sharp and may cause injury. c Important: C Open cover E on the right side of the optional paper cassette unit. Before you install a CompactFlash memory, be sure to discharge any static electricity by touching a grounded piece of metal. Otherwise, you may damage static-sensitive components. A Turn the printer off and unplug the power cord and interface cable. B Open the rear cover by pinching the handle, and remove it.

D Place the printer onto the optional paper cassette unit. Align each of the printer’s corners with those of the optional paper cassette unit. Then lower the printer until it rests securely on the optional paper cassette unit. C Loosen the two screws on the metal cover that appears, and remove it. E Close cover E. F Reconnect the interface cable and power cord, and then turn the printer on. To confirm that the option is installed correctly, print a configuration status sheet. See “Printing a status sheet” on page 65 . ! Caution: If the printer has been in use, the heatsink inside the back cover may be very hot. Be careful not to touch the heatsink. See “Using the printer” on page 7 .

Removing the optional paper cassette unit D Identify the installation slot for a CompactFlash memory. Perform the installation procedure in reverse. CompactFlash memory Installing a CompactFlash memory An optional CompactFlash memory enables you to store overlay forms, use Reserve Job function, and improve the collate printing environment. * CompactFlash memory slot 85