Configuring VTP on a Per-Port Basis With VTP version 3, you can enable or disable VTP on a per-port basis. You can enable VTP only on ports that are in trunk mode. Incoming and outgoing VTP traffic are blocked, not forwarded. Procedure Configuring VTP Configuring VTP on a Per-Port Basis Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface interface-id Example: Device(config)# interface gigabitethernet0/1 Identifies an interface, and enters interface configuration mode. Step 4 vtp Example:
Device(config-if)# vtp Enables VTP on the specified port. Step 5 end Example: Device(config)# end Returns to privileged EXEC mode. Step 6 show running-config interface interface-id Example: Device# show running-config interface gigabitethernet 1/0/1 Verifies the change to the port. Step 7 show vtp status Example: Verifies the configuration. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 16