cisco Catalyst 9300 — Adding a VTP Client to a VTP Domain

Adding a VTP Client to a VTP Domain Follow these steps to verify and reset the VTP configuration revision number on a device before adding it to a VTP domain. Before you begin Before adding a VTP client to a VTP domain, always verify that its VTP configuration revision number is lower than the configuration revision number of the other devices in the VTP domain. Devices in a VTP domain always use the VLAN configuration of the device with the highest VTP configuration revision number. With VTP versions 1 and 2, adding a device that has a revision number higher than the revision number in the VTP domain can erase all VLAN information from the VTP server and VTP domain.

With VTP version 3, the VLAN information is not erased. You can use the vtp mode transparent global configuration command to disable VTP on the device and then to change its VLAN information without affecting the other devices in the VTP domain. Procedure Configuring VTP Adding a VTP Client to a VTP Domain Command or Action Purpose Device# show vtp status Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 show vtp status Example: Device# show vtp status Checks the VTP configuration revision number. If the number is 0, add the device to the VTP domain. If the number is greater than 0, follow these substeps:

• Write down the domain name. • Write down the configuration revision number. • Continue with the next steps to reset the device configuration revision number. Step 3 configure terminal Example: Enters global configuration mode. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 17