• If a switch has 8 trunk ports (200 active VLANs on each trunk) and 40 access ports, the number of STP virtual ports on this switch would be: 8 * 200 + 40 = 1,640 For information about the supported scalability of STP virtual ports, see the Cisco Catalyst 9300 Series Switches Data Sheet . • The device supports IEEE 802.1Q trunking methods for sending VLAN traffic over Ethernet ports. • The interface VLAN already has an MAC address assigned by default. You can override the interface VLAN MAC address by using thee mac-address command.
If this command is configured on a single SVI or router port that requires Layer 3 injected packets, all other SVIs or routed ports on the device also must be configured with the same first four most significant bits (4MSB) of the MAC address. For example, if you set the MAC address of any SVI to xxxx.yyyy.zzzz, set the MAC address of all other SVIs to start with xxxx.yyyy. If Layer 3 injected packets are not used, this restriction does not apply. This applies to all Layer 3 ports, SVIs, and routed ports. This does not apply to GigabitEthernet0/0 port. Note • Once a range of interfaces has been bundled, any VLAN interface configuration change must be done only on a port channel.
Otherwise, the interfaces will get suspended. • If the MAC address of the destination device is not learnt or deleted and there are more than one port mapped to a specific VLAN, then multiple ICMP responses are sent for the traceroute request received on the device. Information About VLANs The following sections provides information about VLANs: Logical Networks A VLAN is a switched network that is logically segmented by function, project team, or application, without regard to the physical locations of the users. VLANs have the same attributes as physical LANs, but you can group end stations even if they are not physically located on the same LAN segment.
Any device port can belong to a VLAN, and unicast, broadcast, and multicast packets are forwarded and flooded only to end stations in the VLAN. Each VLAN is considered a logical network, and packets destined for stations that do not belong to the VLAN must be forwarded through a router or a device supporting fallback bridging. In a switch stack, VLANs can be formed with ports across the stack. Because a VLAN is considered a separate logical network, it contains its own bridge Management Information Base (MIB) information and can support its own implementation of spanning tree. Configuring VLANs Information About VLANs VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 22