Figure 3: VLANs as Logically Defined Networks VLANs are often associated with IP subnetworks. For example, all the end stations in a particular IP subnet belong to the same VLAN. Interface VLAN membership on the device is assigned manually on an interface-by-interface basis. When you assign device interfaces to VLANs by using this method, it is known as interface-based, or static, VLAN membership. Traffic between VLANs must be routed. The device can route traffic between VLANs by using device virtual interfaces (SVIs). An SVI must be explicitly configured and assigned an IP address to route traffic between VLANs.
Supported VLANs The device supports VLANs in VTP client, server, and transparent modes. VLANs are identified by a number from 1 to 4094. VLAN 1 is the default VLAN and is created during system initialization. You can configure up to 4094 VLANs on the device. However, not all VLANs can be active simultaneously. In the MSTP mode, you can configure 1000 active VLANs at any point in time. VLAN IDs 1002 through 1005 are reserved for Token Ring and FDDI VLANs. All of the VLANs except 1002 to 1005 are available for user configuration. There are 3 VTP versions: VTP version 1, version 2, and version 3.
All VTP versions support both normal and extended range VLANs, but only with VTP version 3, does the device propagate extended range VLAN configuration information. When extended range VLANs are created in VTP versions 1 and 2, their configuration information is not propagated. Even the local VTP database entries on the device are not updated, but the extended range VLANs configuration information is created and stored in the running configuration file. By default, VTP versions 1 and 2 support 20 characters for the VLAN name. VTP version 3 supports 128 characters. Configuring VLANs Supported VLANs VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 23