• Bridge identification number for TrBRF VLANs • Ring number for FDDI and TrCRF VLANs • Parent VLAN number for TrCRF VLANs • Spanning Tree Protocol (STP) type for TrCRF VLANs • VLAN number to use when translating from one VLAN type to another You can cause inconsistency in the VLAN database if you attempt to manually delete the vlan.dat file. If you want to modify the VLAN configuration, follow the procedures in this section. Creating or Modifying an Ethernet VLAN Before you begin With VTP version 1 and 2, if the device is in VTP transparent mode, you can assign VLAN IDs greater than 1006, but they are not added to the VLAN database. The device supports only Ethernet interfaces.
Because FDDI and Token Ring VLANs are not locally supported, you only configure FDDI and Token Ring media-specific characteristics for VTP global advertisements to other devices. Although the device does not support Token Ring connections, a remote device with Token Ring connections could be managed from one of the supported devices. Devices running VTP Version 2 advertise information about these Token Ring VLANs: • Token Ring TrBRF VLANs • Token Ring TrCRF VLANs Procedure Configuring VLANs Creating or Modifying an Ethernet VLAN Command or Action Purpose Step 1 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 2 vlan vlan-id Example:
Device(config)# vlan 20 Enters a VLAN ID, and enters VLAN configuration mode. Enter a new VLAN ID to create a VLAN, or enter an existing VLAN ID to modify that VLAN. Note The available VLAN ID range for this command is 1 to 4094. Step 3 name vlan-name Example: (Optional) Enters a name for the VLAN. If no name is entered for the VLAN, the default is to append the vlan-id value with leading zeros to VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 27