cisco Catalyst 9300 — Configuring Load Sharing Using STP Port Priorities

Configuring VLAN Trunks Configuring Load Sharing Using STP Port Priorities Command or Action Purpose Step 11 end Example: Device(config-if)# end Returns to privileged EXEC mode. Step 12 show interfaces interface-id switchport Example: Device# show interfaces gigabitethernet 1/0/1 switchport Verifies the VLAN configuration. Step 13 Repeat the above steps on Device A for a second port in the device. Step 14 Repeat the above steps on Device B to configure the trunk ports that connect to the trunk ports configured on Device A. Step 15 show vlan Example: Device# show vlan When the trunk links come up, VTP passes the VTP and VLAN information to Device B.

This command verifies that Device B has learned the VLAN configuration. Step 16 configure terminal Example: Device# configure terminal Enters global configuration mode on Device A. Step 17 interface interface-id Example: Device(config)# interface gigabitethernet 1/0/1 Defines the interface to set the STP port priority, and enters interface configuration mode. Step 18 spanning-tree vlan vlan-range port-priority priority-value Example: Device(config-if)# spanning-tree vlan 8-10 port-priority 16 Assigns the port priority for the VLAN range specified. Enter a port priority value from 0 to 240. Port priority values increment by 16. Step 19 exit Example: Returns to global configuration mode.

VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 57