C H A P T E R 5 Configuring Private VLANs Prerequisites for Private VLANs, on page 63 Restrictions for Private VLANs, on page 63 Information About Private VLANs, on page 64 How to Configure Private VLANs, on page 75 Monitoring Private VLANs, on page 91 Configuration Examples for Private VLANs, on page 91 Where to Go Next, on page 96 Additional References, on page 96 Feature History for Private VLANs, on page 97 Prerequisites for Private VLANs When configuring private VLANs on the device, always use the default Switch Database Management (SDM) template to balance system resources between unicast routes and Layer 2 entries.
If another SDM template is configured, use the sdm prefer default global configuration command to set the default template. Private VLANs are supported in transparent mode for VTP 1, 2 and 3. Private VLANS are also supported on server mode with VTP 3. Note Restrictions for Private VLANs In some cases, the configuration is accepted with no error messages, but the commands have no effect. Note • Do not configure fallback bridging on the device with private VLANs. • Do not configure a remote SPAN (RSPAN) VLAN as a primary or a secondary VLAN of a private-VLAN. • Do not configure private VLAN ports on interfaces configured for these other features:
• Dynamic-access port VLAN membership VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 63