• If the number of devices in the VLAN increases, the number of assigned address might not be large enough to accommodate them. These problems are reduced by using private VLANs, where all members in the private VLAN share a common address space, which is allocated to the primary VLAN. Hosts are connected to secondary VLANs and the DHCP server assigns them IP addresses from the block of addresses allocated to the primary VLAN. Subsequent IP addresses can be assigned to customer devices in different secondary VLANs, but in the same primary VLAN. When new devices are added, the DHCP server assigns them the next available address from a large pool of subnet addresses.
Private VLANs Across Multiple Switches This section discusses the following topics: • Standard Trunk Ports • Isolated Private VLAN Trunk Ports • Promiscuous Private VLAN Trunk Ports Standard Trunk Ports As with regular VLANs, private VLANs can span multiple switches. A trunk port carries the primary VLAN and secondary VLANs to a neighboring switch. The trunk port treats the private VLAN as any other VLAN. A feature of private VLANs across multiple switches is that traffic from an isolated port in the Switch A does not reach an isolated port on Switch B. Figure 5: Private VLANs Across Switches Private VLANs are supported in transparent mode for VTP 1, 2 and 3.
Private VLAN is also supported on server mode for VTP 3. If you have a server client setup using VTP 3, private VLANs configured on the server should be reflected on the client. Configuring Private VLANs Private VLANs Across Multiple Switches VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 67