Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

^ Filter response /|\ | 10 KHz sampling frequency | | 0 db |____ | | \Diff. | Sum | \ | | | | 4| \ | | | -30 db |____|__\|__|____|______________________\ / | | | | | | / / 05 10 15 20 25 30 / KHz / Desired output frequency Figure 5-7: Some Aliasing Distortion All of this gives rise to the following equation, showing that the sampling frequency must exceed the output frequency by at least 7 KHz, so that the beat frequency will be above the cut-off range of the anti-aliasing filter:

Minimum sampling rate = highest frequency component + 7 KHz The frequency component of the equation is stated as "highest frequency component" because you may be producing a complex waveform with multiple frequency elements, rather than a pure sine wave. LOW-PASS FILTER The system includes a low-pass filter that eliminates aliasing distortion as described above. This filter becomes active around 4 KHz and gradually begins to attenuate (cut off) the signal. Generally, you cannot clearly hear frequencies higher than 7 KHz. Therefore, you get the most complete frequency response in the frequency range of 0 - 7 KHz.

If you are making frequencies from 0 to 7 KHz, you should select a sampling rate no less than 14 KHz, which corresponds to a sampling period in the range 124 to 256. At a sampling period around 320, you begin to lose the higher frequency values between 0 KHz and 7 KHz, as shown in Table 5-6. - 152 Audio Hardware -