Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

6. If the source and destination span the same number of words, use the A channel to mask either the source, as in 4, or the destination, as in 5. NOTE Conditions 2 and 3 can be contradictory if, for instance, you are trying to move an image one pixel down and to the right. In this case, we would want to use descending mode so our destination does not overwrite our source before we use the source, but we would want to use ascending mode for the right shift. In some situations, it is possible to get around general guideline 2 above with clever masking.

But occasionally just masking the first or last word may not be sufficient; it may be necessary to mask more than 16 bits on one or the other end. In such a case, a mask can be built in memory for a single raster row, and the A DMA channel enabled to explicitly fetch this mask. By setting the A modulo value to the negative of the width of the mask, the mask will be repeatedly fetched for each row. AREA FILL MODE In addition to copying data, the blitter can simultaneously perform a fill operation during the copy. The fill operation has only one restriction - the area to fill must be defined first by drawing untextured lines with only one bit set per horizontal row.

A special line draw mode is available for this operation. Use a standard copy blit (or any other blit, as area fills take place after all shifts, masks and logical combination of sources). Descending mode must be used. Set either the inclusive-fill-enable bit (FILL OR, or bit 3) or the exclusive-fill-enable bit (FILL XOR, or bit 4) in BLTCON1. The inclusive fill mode fills between lines, leaving the lines intact. The exclusive fill mode fills between lines, leaving the lines bordering the right edge of filled regions but deleting the lines bordering the left edge. Exclusive fill yields filled shapes one pixel narrower than the same pattern filled with inclusive fill.

For instance, the pattern: 00100100-00011000 filled with inclusive fill, yields: 00111100-00011000 with exclusive fill, the result would be 00011100-00001000 (Of course, fills are always done on full 16-bit words.) - 178 Blitter Hardware -