There is another bit (FILL_CARRYIN or bit 3 in BLTCON1) that forces the area "outside" the lines be filled; for the above example, with inclusive fill, the output would be; 11100111-11111111 with exclusive fill, the output would be; 11100011-11110111 BEFORE AFTER ____________________ ___________________ | | | | | 1 1 1 1 | | 11111 11111 | | 1 1 1 1 | | 11111 11111 | | 1 1 1 1 | | 1111 1111 | | 1 1 1 1 | | 111 111 | | 11 11 | | 11 11 | | 1 1 1 1 | | 111 111 | | 1 1 1 1 | | 1111 1111 | | 1 1 1 1 | | 11111 11111 | |____________________| |___________________| Figure 6-5:
Use of the FCI Bit - Bit Is a 0 If the FCI bit is a 1 instead of a 0, the area outside the lines is filled with ls and the area inside the lines is left with 0s in between. BEFORE AFTER ____________________ ___________________ | | | | | 1 1 1 1 | |111 1111111 11| | 1 1 1 1 | |111 11111111 11| | 1 1 1 1 | |1111 111111111 11| | 1 1 1 1 | |11111 1111111111 11| | 11 11 | |1111111111111111111| | 1 1 1 1 | |11111 1111111111 11| | 1 1 1 1 | |1111 111111111 11| | 1 1 1 1 | |111 11111111 11| |____________________| |___________________| Figure 6-6: Use of the FCI Bit - Bit Is a 1 If you wish to produce very sharp, single-point vertices, exclusive-fill enable must be used.
Figure 6-7 shows how a single-point vertex is produced using exclusive-fill enable. - Blitter Hardware 179 -