BLITTER KEY POINTS This is a list of some key points that should be remembered when programming the blitter. o Write BLTSIZE last; writing this register starts the blit. o Modulos and pointers are in bytes; width is in words and height is in pixels. The least significant bit of all pointers and modules is ignored. o The order of operations in the blitter is masking, shifting, logical combination of sources, area fill, and zero nag setting. o In ascending mode, the blitter increments the pointers, adds the modules, and shifts to the right. o In descending mode, the blitter decrements the pointers, subtracts the modules, and shifts to the left.
o Area fill only works correctly in descending mode. o Check BLTDONE before writing blitter registers or using the results of a blit. o Shifts are done on immediate data as soon as it is loaded. EXAMPLE: ClearMem ; ; Blitter example - memory clear ; include 'exec/types.i' include 'hardware/custom.i' include 'hardware/dmabits.i' include 'hardware/blit.i' include 'hardware/hw examples.i" xref _custom ; ; Wait for previous blit to complete. ; waitblit: btst.b #DMAB_BLTDONE-8,DMACONR(a1) waitblit2: btst.b #DMAB_BLTDONE-8,DMACONR(a1) bne waitblit2 rts ; ; This routine uses a side effect in the blitter. When each - Blitter Hardware 195 -