Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

; of the blits is finished, the pointer in the blitter is pointing ; to the next word to be blitted. ; ; When this routine returns, the last blit is started and might ; not be finished, so be sure to call waitblit above before ; assuming the data is clear. ; ; a0 pointer to first word to clear ; d0 - number of bytes to clear (must be even) ; xdef clearmem clearmem:

lea custom,a1 ; Get pointer to chip registers bsr waitblit ; Make sure previous blit is done move.l a0,BLTDPT(a1) ; Set up the D pointer to the region to ; clear clr.w BLTDMOD(a1) ; Clear the D modulo (don't skip no bytes) asr.l #1,d0 ; Get number of words from number of bytes clr.w BLTCON1(a1) ; No special modes move.w #DEST,BLTCON0(a1); only enable destination ; ; First we deal with the smaller blits ; moveq #$3f,d1 ; Mask out mod 64 words and.w d0,d1 beq dorest ; none? good, do one blit sub.l d1,d0 ; otherwise remove remainder or.l #$40,d1 ; set the height to 1, width to n move.w d1,BLTSIZE(a1) ; trigger the blit ; ; Here we do the rest of the words, as chunks of 128k ; dorest:

move.w #$ffc0,d1 ; look at some more upper bits and.w d0,d1 ; extract 10 more bits beq dorest2 ; any to do? sub.l d1,d0 ; pull of the ones we're doing here bsr waitblit ; wait for prev blit to complete move.w d0,BLTSIZE(a1) ; do another blit dorest2: swap d0 ; more? beq done ; nope. clr.w d1 ; do a 1024x64 word blit (128K) keepon: bsr waitblit ; finish up this blit move.w d1,BLTSIZE(a1) ; and again, blit subq.w #1,d0 ; still more? bne keepon ; keep on going. done: rts ; finished. Blit still in progress. end - 196 Blitter Hardware -