Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

CIAAPRA/CIABPRB - DISK SELECTION, CONTROL AND SENSING The following Table lists how 8520 chip bits used by the disk subsystem. Bits labelled "PA" are input bits in CIAAPRA ($BFE001). Bits labelled "PB" are output bits located in CIAAPRB ($BFD100). More information on how the 8520 chips operate can be found in Appendix F. Table 8-5: Disk Subsystem Bit Name Function PA5 DSKRDY* Disk ready (active low). The drive will pull this line low when the motor is known to be rotating at full speed. This signal is only valid when the motor is ON, at other times configuration information may obscure the meaning of this input. PA4 DSKTRACK0* Track zero detect.

The drive will pull this line low when the disk heads are positioned over track zero. Software must not attempt to step outwards when this signal is active. Some drives will refuse to step, others will attempt the step, possibly causing alignment damage. All new drives must refuse to step outward in this condition. PA3 DSKPROT* Disk is write protected (active low). PA2 DSKCHANGE* Disk has been removed from the drive. The signal goes low whenever a disk is removed. It remains low until a disk is inserted AND a step pulse is received. PB7 DSKMOTOR* Disk motor control (active low). This signal is nonstandard on the Amiga system.

Each drive will latch the motor signal at the time its select signal turns on. The disk drive motor will stay in this state until the next time select turns on. DSKMOTOR* also controls the activity light on the front of the disk drive. All software that selects drives must set up the motor signal before selecting any drives. The drive will "remember" the state of its motor when it is not selected. All drive motors turn off after system reset. - 238 Interface Hardware -