Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

After turning on the motor, software must further wait for one half second (500ms), or for the DSKRDY* line to go low. PB6 DSKSEL3* Select drive 3 (active low). PB5 DSKSEL2* Select drive (active low). PB4 DSKSEL1* Select drive 1 (active low). PB3 DSKSEL0* Select drive 0 (internal drive) (active low). PB2 DSKSIDE Specify which disk head to use. Zero indicates the upper head. DSKSIDE must be sTable for 100 microseconds before writing. After writing, at least 1.3 milliseconds must pass before switching DSKSIDE. PB1 DSKDIREC Specify the direction to seek the heads. Zero implies seek towards the centre spindle. Track zero is at the outside of the disk.

This line must be set up before the actual step pulse, with a separate write to the register. PB0 DSKSTEP* Step the heads of the disk. This signal must always be used as a quick pulse (high, momentarily low, then high). The drives used for the Amiga are guaranteed to get to the next track within 3 milliseconds. Some drives will support a much faster rate, others will fail. Loops that decrement a counter to provide delay are not accepTable. See Appendix F for a better solution. When reversing directions, a minimum of 18 milliseconds delay is required from the last step pulse. Settle time for Amiga drives is specified at 15 milliseconds. FLAG DSKINDEX* Disk index pulse ($BFDD00, bit 4).

Can be used to create a level 6 interrupt. See Appendix F for details. - Interface Hardware 239 -