DMACON 096 W A D P DMA control write (clear or set) DMACONR 002 R A P DMA control (and blitter status) read This register controls all of the DMA channels and contains blitter DMA status bits. BIT FUNCTION DESCRIPTION 15 SET/CLR Set/clear control bit. Determines if bits written with a 1 get set or cleared. Bits written with a zero are unchanged. 14 BBUSY Blitter busy status bit (read only) 13 BZERO Blitter logic zero status bit (read only). 12 X 11 X 10 BLTPRI Blitter DMA priority (over CPU micro) (also called "blitter nasty") (disables /BLS pin, preventing micro from stealing any bus cycles while blitter DMA is running).
09 DMAEN Enable all DMA below 08 BPLEN Bit plane DMA enable 07 COPEN Copper DMA enable 06 BLTEN Blitter DMA enable 05 SPREN Sprite DMA enable 04 DSKEN Disk DMA enable 03 AUD3EN Audio channel 3 DMA enable 02 AUD2EN Audio channel 2 DMA enable 01 AUD1EN Audio channel 1 DMA enable 00 AUD0EN Audio channel 0 DMA enable DSKBYTR 01A R P Disk data byte and status read This register is the disk-microprocessor data buffer. Data from the disk (in read mode) is loaded into this register one byte at a time, and bit 15 (DSKBYT) is set true.
BIT --------------------------------------------------- 15 DSKBYT Disk byte ready (reset on read) 14 DMAON Mirror of bit 15 (DMAEN) in DSKLEN, ANDed with Bit 09 (DMAEN) in DMACON 13 DISKWRITE Mirror of bit 14 (WRITE) in DSKLEN 12 WORDEQUAL This bit true only while the DSKSYNC register equals the data from disk. 11-08 X Not used 07-00 DATA Disk byte data - 272 Appendix A -