Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

SERPER 032 W P Serial port period and control This register contains the control bit LONG referred to above, and a 15-bit number defining the serial port baud rate. If this number is N, then the baud rate is 1 bit every (N+1) * 0.2794 microseconds. BIT# SYM FUNCTION -------------------------------------------------------------- 15 LONG Defines serial receive as 9-bit word. 14-00 RATE Defines baud rate=1/ ( (N+1) * 0.2794 microsec. SPRxCTL 142 W A D Sprite x vert stop position and control data SPRxPOS 140 W A D Sprite x vert-horiz start position data These two registers work together as position, size and feature sprite-control registers.

They are usually loaded by the sprite DMA channel during horizontal blank; however, they may be loaded by either processor at any time. SPRxPOS register: BIT# SYM FUNCTION ------------------------------------------------------------------ 15-08 SV7-SV0 Start vertical value. High bit(SV8) is in SPRxCTL register below. 07-00 SH8-SH1 Start horizontal value. Low bit(SH0) is in SPRxCTL register below. SPRxCTL register (writing this address disables sprite horizontal comparator circuit):

BIT# SYM FUNCTION ------------------------------------------------------------ 15-08 EV7-EV0 End (stop) vertical value low 8 bits 07 ATT Sprite attach control bit (odd sprites) 06-04 X Not used 02 SV8 Start vertical value high bit 01 EV8 End (stop) vertical value high bit 00 SH0 Start horizontal value low bit SPRxDATA 144 W D Sprite x image data register A SPRxDATB 146 W D Sprite x image data register B These registers buffer the sprite image data. They are usually loaded by the sprite DMA channel but may be loaded by either processor at any time. When a horizontal comparison occurs, the buffers are dumped into shift registers and serially outputted to the display, MSB first on the left.

NOTE: Writing to the A buffer enables (arms) the sprite. Writing to the SPRxCTL register disables the sprite. If enabled, data in the A and B buffers will be outputted whenever the beam counter equals the sprite horizontal position value in the SPRxPOS register. SPRxPOS see SPRxCTL - 278 Appendix A -