Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

SPRxPTH 120 W A Sprite x pointer (high 3 bits) SPRxPTL 122 W A Sprite x pointer (low 15 bits) This pair of registers contains the 18-bit address of sprite x (x=0,1,2,3,4,5,6,7) DMA data. These address registers must be initialized by the processor or Copper every vertical blank time. STREQU 038 S D Strobe for horizontal sync with VB and EQU STRHOR 03C 5 D P Strobe for horizontal sync STRLONG 03E 5 D Strobe for identification of long horizontal line One of the first three strobe addresses above is placed on the destination address bus during the first refresh time slot.

The fourth strobe shown above is used during the second refresh time slot of every other line to identify lines with long counts (228). There are four refresh time slots, and any not used for strobes will leave a null (FF) address on the destination address bus.

STRVBL 03A 5 D Strobe for horizontal sync with VB (vertical blank) VHPOSR 006 R A Read vertical and horizontal position of beam or lightpen VHPOSW 02C W A Write vertical and horizontal position of beam or lightpen BIT# 15,14,13,12,11,10,09,03,07,06,05,04,03,02,01,00 ----------------------------------------------------- USE V7 V6 V5 V4 V3 V2 V1 V0,H8 H7 H6 H5 H4 H3 H2 H1 RESOLUTION=1/160 of screen width (280 ns) VPOSR 004 R A Read vertical most significant bit (and frame flop) VPOSW 02A W A Write vertical most significant bit (and frame flop) BIT 15,14,13,12,11,10,09,08,07,06,05,04,03,02,01,00 USE LOF V8 LOF=Long frame (auto toggle control bit in BPLCON0) - Appendix A 279 -