SERIAL INTERFACE CONNECTOR SPECIFICATION This 25-pin D-type connector with sockets (DB255=female) is used to interface to RS-232-C standard signals. Signal names correspond to those used in other places in this appendix, when possible. WARNING: Pin on the R5232 connector other than these standard ones described below may be connected to power or other non-R5232 standard signals. When making up RS232 cables, connect only those pins actually used for particular application. Avoid generic 25-connector "straight- thru" cables.
SERIAL INTERFACE CONNECTOR PIN ASSIGNMENT (J6) R5-232-C NAME DIR STD NOTES ---- --- --- ------------------------------- FGND y Frame ground -- do not tie to signal ground TXD O y Transmit data RXD I y Receive data RTS O y Request to send CTS I y Clear to send DSR I y Data set ready GND y Signal ground -- do not tie to frame ground CD I y Carrier detect -5V n* 50 ma maximum *** WARNING -5V *** AUDO O n* Audio output from left (channels 0, 3) port, intended to send audio to the modem. AUDI I n* Audio input to right (channels 1, 2) port, intended to receive audio from the modem; this input is mixed with the analog output of the right (channels 1, 2).
It is not digitized or used by the computer in any way. DTR O y Data terminal ready. RI I y Ring Indicator (A500/A2000 only) shared with printer "select" signal. RESB* O n* Amiga system reset. NOTES: n*: See warning above See part 1 of this appendix for pin numbers. SERIAL INTERFACE CONNECTOR TIMING Maximum operating frequency is 19.2 KHz. Refer to EIA standard R5-232-C for operating and installation specifications. A rate of 31.25 KHz will be supported through the use of a MIDI adapter. Modem control signals (CTS, RTS, DTR, DSR, CD) are completely under software control. The modem control lines have no hardware affect on and are completely asynchronous to TXD and RXD. - 304 Appendix E -