Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

SERIAL INTERFACE CONNECTOR ELECTRICAL CHARACTERISTICS OUTPUTS MIN TYP MAX ------- --- --- --- Vo(-): 13.2 -x- -2.5 V Negative output voltage range Vo(+): 8.0 -x- 13.2 V Positive output voltage range Io: -x- -x- 10.0 ma Output current INPUTS MIN TYP MAX ------ --- --- --- Vi(+): 3.0 -x- 25.0 V Positive input voltage range Vi(-): 25.0 -x- 0.5 V Negative input voltage range Vhy: -x- 1.0 -x- V Input hysteresis voltage Ii: 0.3 -x- 10.0 ma Input current Unconnected inputs are interpreted the same as positive input voltages. GAME CONTROLLER INTERFACE CONNECTOR SPECIFICATION The two 9-pin D-type connectors with pins (male) are used to interface to four types of devices: 1.

Mouse or trackball, 3 buttons max. 2. Digital joystick, 2 button max. 3. Proportional (pot or proportional joystick), 2 buttons max. 4. Light pen, including pen-pressed-to-screen button. The connector pin alignment are discussed in sections organized by similar hardware and/or software operating requirements as shown in the previous list. Signal names follow those used elsewhere in this appendix, when possible. J11 is the right controller port connector (JOY1DAT, POT1DAT). J12 is the left controller port connector (JOY0DAT, POT0DAT). NOTE: While most of the hardware discussed below is directly accessible, hardware should be accessed through ROM kernel software.

This will keep future hardware changes transparent to the user. - Appendix E 305 -