; A complete 8520 timing example. This blinks the power light at (exactly) ; 3 millisecond intervals. It takes over the machine, 50 watch out! ; ; The base Amiga crystal frequencies are: ; NTSC 28.63636 MHz ; PAL 28.37516 MHz ; ; The two 16 bit timers on the 8520 chips each count down at 1/10 the CPU ; clock, or 0.715909 MHz. That works out to 1.3968255 microseconds per count. ; Under PAL the countdown is slightly slower, 0.709379 MHz. ; ; To wait 1/100 second would require waiting 10,000 microseconds. ; The timer register would be set to (10,000 / 1.3968255 - 7159). ; ; To wait 3 milliseconds would require waiting 3000 microseconds. ; The register would be set to (3000 / 1.3968255 - 2148).
INCLUDE "hardware/cia.i" INCLUDE "hardware/custom.i" ; XREF _ciaa XREF _ciab XREF _custom ; lea _custom,a3 ; Base of custom chips lea _ciaa,a4 ; Get base address if CIA-A ; move.w S7fff,dmacon(a3) ; Kill all chip interrupts ; ; Setup, only do once ; This set all bits needed for timer A one-shot mode. ; move.b ciacra(a4),d0 ;Set control register A on CIAA and.b #%11000000,d0 ;Don't trash bits we are not or.b #%00001000,d0 ;using...
move.b d0,ciacra(a4) move.b #%01111111,ciaicr(a4) ;Clear all 8520 interrupts ; Set time (low byte THEN high byte) And the low order with $ff Shift the high order by 8 ; TIME equ 2148 move.b (TIME&$FF),ciatalo(a4) move.b (TIME>>8),ciatahi(a4) ; ; Wait for the timer to count down busy_wait: ; btst.b #0,ciaicr(a4) ;Wait for timer expired flag beq.s busy wait bchg.b #CIAB LED,ciapra(a4) ;Blink light bset.b #0,ciacra(a4) ;Restart timer bra.s busy_wait END - Appendix F 331 -