Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

HARDWARE CONNECTION DETAILS The system hardware selects the CIAs when the upper three address bits are 101. Furthermore, CIAA is selected when A12 is low, A13 high; CIAB is selected when A12 is high, A13 low. CIAA communicates on data bits 7-0, CIAB communicates on data bits 15-8. Address bits A11, A10, A9, and A8 are used to specify which of the 16 internal registers you want to access. This is indicated by "r" in the address. All other bits are don't cares. So, CIAA is selected by the following binary address: 101x xxxx xx01 rrrr xxxx xxx0. CIAB address: 101x xxxx xx10 rrrr xxxx xxx1 With future expansion in mind, we have decided on the following addresses: CIAA = BFEr01; CIAB = BFDr00.

Software must use byte accesses to these address, and no other. INTERFACE SIGNALS CLOCK INPUT The 02 clock is a TTL compatible input used for internal device operation and as a timing reference for communicating with the system data bus. On the Amiga, this is connected to the 68000 "E" clock. The "E" clock runs at 1/10 of the CPU clock. This works out to .715909 Mhz for NTSC or .709379 Mhz for PAL. CS - CHIP-SELECT INPUT The CS input controls the activity of the 8520. A low level on CS while 02 is high causes the device to respond to signals on the R/W and address (RS) lines. A high on CS prevents these lines from controlling the 8520.

The CS line is normally activated (low) at 02 by the appropriate address combination. R/W - READ/WRITE INPUT The RW signal is normally supplied by the microprocessor and controls the direction of data transfers of the 8520. A high on R/W indicates a read (data transfer out of the 8520), while a low indicates a write (data transfer into the 8520). - 332 Appendix F -