RSRS0 - ADDRESS INPUTS The address inputs select the internal registers as described by the register map. DB7-DB0 - DATA BUS INPUTS/OUTPUTS The eight data bus output pins transfer information between the 8520 and the system data bus. These pins are high impedance inputs unless CS is low and R/W and 02 are high, to read the device. During this read, the data bus output buffers are enabled, driving the data from the selected register onto the system data bus. IRQ - INTERRUPT REQUEST OUTPUT IRQ is an open drain output normally connected to the processor interrupt input. An external pull-up resistor holds the signal high, allowing multiple IRQ outputs to be connected together.
The IRQ output is normally off (high impedance) and is activated low as indicated in the functional description. RES - RESET INPUT A low on the RES pin resets all internal registers. The port pins are set as inputs and port registers to zero (although a read of the ports will return all highs because of passive pull-ups). The timer control registers are set to zero and the timer latches to all ones. All other registers are reset to zero. - Appendix F 333 –