You select the number of bit-planes by writing the number into the register BPLCON0 (for Bit Plane Control Register 0) The relevant bits are bits 14, 13, and 12, named BPU2, BPU1, and BPU0 (for "Bit Planes Used"). Table 3-5 shows the values to write to these bits and how the system assigns bit-plane numbers. Table 3-5: Setting the Number of Bit-Planes Number of Name(s) of Value Bit-Planes Bit-Planes 000 None * 001 1 PLANE 1 010 2 PLANES 1 and 2 011 3 PLANES 1 - 3 100 4 PLANES 1 - 4 101 5 PLANES 1 - 5 110 6 PLANES 1 - 6 ** 111 7 Value not used. * Shows only a background color; no playfield is visible.
** Sixth bit-plane is used only in dual-playfield mode and in hold-and- modify mode (described in the section called "Advanced Topics"). NOTE The bits in the BPLCON0 register cannot be set independently. To set any one bit, you must reload them all. The following example shows how to tell the system to use two low-resolution bit-planes. MOVE.W #$2200,BPLCON0+CUSTOM ; Write to it Because register BPLCON0 is used for setting other characteristics of the display and the bits are not independently, the example above also sets other parameters (all of these parameters are described later in the chapter). o Hold-and-modify mode is turned off. o Single-playfield mode is set.
o Composite video color is enabled. (Not applicable in all models.) - 42 Playfield Hardware -