To set interlaced or non-interlaced mode, you write to bit 2, LACE, in register BPLCON0: Interlaced mode write 1 to bit 2. Non-interlaced mode write 0 to bit 2. As explained above in "Setting the Number of Bit-Planes," bits in BPLCON0 are not independently set. The following example shows how to specify high-resolution and interlaced modes. MOVE.W #$A204,BPLCON0+CUSTOM ; Write to it The example above also sets the following parameters that are also controlled through register BPLCON0: o High-resolution mode is enabled. o Two bit-planes are used. o Hold-and-modify mode is disabled. o Single-playfield mode is enabled. o Composite video color is enabled. o Genlock audio is disabled.
o Light pen is disabled. o Interlaced mode is enabled. o External resynchronization is disabled. The amount of memory you need to allocate for each bit-plane depends upon the resolution modes you have selected, because high-resolution or interlaced playfields contain more data and require larger bit-planes. - Playfield Hardware 45 -