Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

ALLOCATING MEMORY FOR BIT-PLANES After you set the number of bit-planes and specify resolution modes, you are ready to allocate memory. A bit-plane consists of an end-to-end sequence of words at consecutive memory locations. When operating under the Amiga operating system, use a system call such as AllocMem() to remove a block of memory from the free list and make it available to the program. If the machine has been taken over, simply reserve an area of memory for the bit-planes. Next, set the bit plane pointer registers (BPLxPTH/BPLxPTL) to point to the starting memory address of each bitplane you are using.

The starting address is the memory word that contains the bits of the upper left-hand corner of the bit-plane. Table 3-6 shows how much memory is needed for basic playfields. You may need to balance your color and resolution requirements against the amount of available memory you have. Table 3-7: Playfield Memory Requirements, NTSC Number of Bytes Picture Size Modes per Bit-Plane 320 X 200 Low-resolution, 8,000 non-interlaced 320 X 400 Low-resolution, 16,000 interlaced 640 X 200 High-resolution, 16,000 non-interlaced 640 X 400 High-resolution, 32,000 interlaced - 46 Playfield Hardware -