Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

After the first line is fetched, the bit-plane pointers BPLxPTH and BPLxPTL contain the value START+40. The modulo (in this case, 0) is added to the current value of the pointer, so when the pointer begins the data fetch for the next line, it fetches the data you want on that line. The data for the next line begins at memory location START+40. Data for Line 2: Location: START+40 START+42 START+44 .....START+78 Leftmost Next Word Next Word Last Display Display Word Word Figure 3-11: Data Fetched for the Second Line When Modulo = 0 Note that the pointers always contain an even number, because data is fetched from the display a word at a time.

There are two modulo registers, BPL1MOD for the odd-numbered bit-planes and BPL2MOD for the even-numbered bit-planes. This allows for differing modules for each playfield in dual-playfield mode. For normal applications, both BPL1MOD and BPL2MOD will be the same. The following example sets the modulo to 0 for a low-resolution playfield with one bit- plane. The bit-plane is odd-numbered. MOVE.W #0,BPL1MOD+CUSTOM ; Set modulo to 0 DATA FETCH IN HIGH-RESOLUTION MODE When you are using high-resolution mode to display the basic playfield, you need to fetch 80 bytes for each line, instead of 40.

MODULO IN INTERLACED MODE For interlaced mode, you must redefine the modulo, because interlaced mode uses two separate scanning’s of the video screen for a single display of the playfield. During the first scanning, the odd-numbered lines are fetched to the screen; and during the second scanning, the even-numbered lines are fetched. - Playfield Hardware 55 -