The bit-planes for a full-screen-sized, interlaced display are 400 NTSC (512 PAL), rather than 200 NTSC (256 PAL), lines long. Assuming that the playfield in memory is the normal 320 pixels wide, data for the interlaced picture begins at the following locations (these are all byte addresses): Line 1 START Line 2 START+40 Line 3 START+80 Line 4 START+120 and so on. Therefore, you use a modulo of 40 to skip the lines in the other field. For odd fields, the bit-plane pointers begin at START. For even fields, the bit-plane pointers begin at START+40 You can use the Copper to handle resetting of the bit-plane pointers for interlaced displays.
DISPLAYING AND REDISPLAYING THE PLAYFIELD You start playfield display by making certain that The bit-plane pointers are set and bit- plane DMA is turned on. You turn on bit-plane DMA by writing a 1 to bit BPLEN in the DMACON (for DMA control) register. See Chapter 7, "System Control Hardware," for instructions on setting this register. Each time The playfield is redisplayed, you have to reset the bit-plane pointers. Resetting is necessary because the pointers have been incremented to point to each successive word in memory and must be repointed to the first word for the next display.
You write Copper instructions to handle the redisplay or perform this operation as part of a vertical blanking task. ENABLING THE COLOR DISPLAY The stock A1000 has a color composite output and requires bit 9 set in BPLCON0 to create a color composite display signal. Without the addition of specialized hardware, the A500 and A2000 cannot generate color composite output. NOTE The color burst enable does not affect the RGB video signal. RGB video is correctly generated regardless of the output of the composite video signal. - 56 Playfield Hardware -