BASIC PLAYFIELD SUMMARY The steps for defining a basic playfield are summarized below: 1. Define Playfield Characteristics a. Specify height in lines: o For NTSC: * 200 for non-interlaced mode. * 400 for interlaced mode. o For PAL: * 256 for non-interlaced mode. * 512 for interlaced mode. b. Specify width in pixels: o 320 for low-resolution mode. o 640 for high-resolution mode. c. Specify color for each pixel: o Load desired colors in color table registers. o Define color of each pixel in terms of the binary value that points at the desired color register. o Build bit-planes. o Set bit-plane registers. * Bits 12-14 in BPLCON0 - number of bit-planes (BPU2 - BPU0).
* BPLxPTH - pointer to bit-plane starting position in memory (written as a long word). - 57 Playfield Hardware -