because the rightmost limit remains ($D8) and only one word is fetched at this limit. However, horizontal blanking actually limits the displayable video to 368 low-resolution pixels (23 words). These numbers are the same both for NTSC and for PAL. In addition, it should be noted that using a data-fetch start earlier than ($38) will disable some sprites. Table 3-14:
Maximum Allowable Horizontal Screen Video LoRes HiRes DDFSTRT (standard) $0038 $003C DDFSTOP (standard) $00D0 $00d4 DDFSTRT (hw limits) $0018 $0018 DDFSTOP (hw limits) $00D8 $00D8 max words fetched 25 49 max display pixels 368 (low res) MOVING (SCROLLING) PLAYFIELDS If you want a background display that moves, you can design a playfield larger than the display window and scroll it. If you are using dual playfields, you can scroll them separately. In vertical scrolling, the playfield appears to move smoothly up or down on the screen.
All you need do for vertical scrolling is progressively increase or decrease the starting address for the bit-plane pointers by the size of a horizontal line in the playfield. This has the effect of showing a lower or higher part of the picture each field time. In horizontal scrolling the playfield appears to move from right-to-left or left-to-right on the screen. Horizontal scrolling works differently from vertical scrolling you must arrange to fetch one more word of data for each display line and delay the display of this data. For either type of scrolling, resetting of pointers or data-fetch registers can be handled by the Copper during the vertical blanking interval.
VERTICAL SCROLLING You can scroll a playfield upward or downward in the window. Each time you display the playfield, the bit-plane pointers start at a progressively higher or lower place in the big picture in memory. As the value of the pointer increases, more of the lower part of the picture is shown and the picture appears to scroll upward. As the value of the pointer decreases, more of the upper part - Playfield Hardware 75 -