6-8 Using Preferences U G Preferences window. tions or Cancel to cancel them. Selecting either OK or Cancel returns you to the 1 ) When you're through changing these settings, select OK to confirm your selec- method. i '> select xON/xOFF, RTS/CTS, or none if you do not need either - - control the flow of information through the serial connector. You can Handshaking. This setting lets you specify one of two methods to \ i Even to specify even parity, Odd for odd parity, or None for no parity .' i checking. Parity. Parity is a method for reducing transmission errors. Select number expected at the end of each character that is read. 1 !
added to each character sent through the serial connector and the where it ends. You can select either 1 or 2. This is the number of bits Stop Bits. Stop bits are bits added to the end of a character that mark ! ' either 7 or 8 bits. connector for each character. As with the Read Bits,the setting is \ / Write Bits. This is the number of bits that are sent through the serial received through the serial connector. You can select either 7 or 8 bits. 1 ( Read Bits. This is the number of bits expected for each character right of the size. serial communication. Its size is shown immediately below the words L-J Buffer Size. To change it, select either the Up or Down arrow to the Buffer Size.
The Serial buffer is an area of memory set aside for the Up or Down arrow to the right of the rate. ' ( below the words Baud Rate. To change the Baud Rate, select either connnector each second. The current rate is shown immediately Baud Rate. This is the number of bits transferred through the serial 1 ' The serial settings are: