When Installing Internal Options Integrated circuit (lC) chips are sensitive to static electricity. When handling electronic components containing IC chips, including expansion boards and RAM modules, always take precautions to reduce the chances of electrostatic discharge (ESD) harming the components. 1. Use a Phillips-head screwdriver to remove the two screws at the upper corners of the rear of the main unit. Because optional items can occasionally have unforeseen interactions, Commodore strongly recommends that new expansion devices be tested first without any other expansion devices connected.
If you experience problems after installing any device, try removing any other optional items from the system, and test the new item by itself, then in various combinations with other items. Often a solution to the problem can be found when the interacting items are identified. Touching a nearby grounded metal surface before touching a component drains static electricity, reducing the likelihood of ESD damage. 2. Grasp the cover on both sides as illustrated in Figure 3-1, and slide it backward and up. Removing the Cover To remove the Amiga's cover: ESD Precautions 3-6 Note